Heser PValve Blanking Plug

The "Blind plug for PValve" is used to close a hole intended for the installation
hole with a diameter of 19-20mm intended for the installation of a PValve
in a dry suit.
The "Blind plug for PValve" does not need to be glued in and
can be removed at any time. Damaged or excessively de-
formed O-rings must then be replaced. deformed O-rings must then be replaced.

Included in delivery:

•  1 x blind cap

The relevance of the safety instructions always depends on the degree of difficulty of the dive and its requirements. The same applies to the execution of technical work.These safety instructions can therefore not be considered comprehensive.

• The user must always be provided with the product description.
• The product may only be used for its intended purpose.
• The training and level of knowledge must fully cover the intended use.
• The user's level of training may restrict the intended use.
• If the user does not understand this description or has doubts, he must not use the product.
• These instructions are not a substitute for training.
• Defective, worn or modified products must not be used.
• The contact of normal steel parts with stainless steel parts also leads to rust stains on stainless steel parts.

• If you are unsure about the installation, have the blanking plate installed by specialist personnel.