Rebreather-Backplate 4,8kg / 4mm (10.6 lbs / 0.16 inch)

The backplate is made in the same design and quality as our standard short backplates. This backplate is manufactured according to customer specifications. It is a special back plate for use with a rebreather. Due to the long design, the backplate rests on the buttocks of the divers. Since most rebreather are too short to be on the buttocks. Backplate with normal length press the lumbar area, which often caused back pain.

Characteristics:

• Backplate Material: 4mm (0.16inch), about 4,8kg (10.6 lbs) salt-water resistant stainless steel (1.4571 ; 316Ti)
• Surface: matt (blastend)
• Dimensions: Length = 552mm (21.7 inch) (152mm longer than standard backplates), width = 270mm (10.6 inch) approx
• Spacing of hole: 11 inch = 279,4 mm (Fits to every wing with spacing of hole of 11 inch)
• 4m (13 feet) harness webbing with eyelet: about 50mm (2 inch) broad, 3mm (0.12 inch) thick (extra strong)
• Crotch strap, one end sewed up with D-ring and stopper
• 2 x D-Ring, 5mm diameter 45°
• 2 x D-Ring, 5mm diameter
• 1 x screws with nuts and shims to mount crotch strap
• 1 x stopper toothless
• 5 x stopper
• 1 x bangee loop
• 1 x fastener for harness
• 4 x rubber rings to fix backup lights
• dimensional drawing (PDF)
• Every metal accessories are made of saltwater resistant stainless steel

Note: The set will be delivered unmounted.

The relevance of the safety instructions always depends on the degree of difficulty of the dive and its requirements. The same applies to the execution of technical work.These safety instructions can therefore not be considered comprehensive.

• The user must always be provided with the product description.
• The product may only be used for its intended purpose.
• The training and level of knowledge must fully cover the intended use.
• The user's level of training may restrict the intended use.
• If the user does not understand this description or has doubts, he must not use the product.
• These instructions are not a substitute for training.
• Defective, worn or modified products must not be used.
• The contact of normal steel parts with stainless steel parts also leads to rust stains on stainless steel parts.