Push button for storage pack for easy attachment to the backplate

Video about the push button

The push button is used to attach the Storage Pack to the backplate. Ideally, one side of the Storage Pack is fastened with screws, the other side with 3 pressure heads. This makes it possible to remove the Storage Pack on one side in order to access the screws of the double tank attachment or the single tank adapter.

Attention: The push button only works with backplates with 11mm holes.

There is no screwdriver included. The screwdriver for the Heser-PValve also fits here. The push button is supplied unassembled.

Scope of delivery:

• 1 x black Plastic Button
• 1 x O-ring
• 1 x Screw
• 1 x Washer

The relevance of the safety instructions always depends on the degree of difficulty of the dive and its requirements. The same applies to the execution of technical work.These safety instructions can therefore not be considered comprehensive.

• The user must always be provided with the product description.
• The product may only be used for its intended purpose.
• The training and level of knowledge must fully cover the intended use.
• The user's level of training may restrict the intended use.
• If the user does not understand this description or has doubts, he must not use the product.
• These instructions are not a substitute for training.
• Defective, worn or modified products must not be used.
• The contact of normal steel parts with stainless steel parts also leads to rust stains on stainless steel parts.

• The Heser Backplate Storage Pack must not be fastened at all fastening points with these press studs. Screws must be used at least at two points.